mass air

[Red88 RICK]

hey not sure if this should be a tech but its just a quick question.
If im doing the massair conversion can u use the connector off the mass air meater with the wires cut and just add on some wire and does anyone know if a ford dealership would carry the pins in stock or any other parts shop would have the pins or do i have to just go and get a new harness from a online store? because i am going to get a copmuter and meater today and im pretty sure i can go find a cut connector for the meater at a junkyard or soemthing. i wanted to do it today not like wait a week for a harness

 

[jrichker]

You can cut a harness up to get the required parts. Not a neat way to do it, but it can be done. I recommend that you order a harness kit and the pins you will need. See http://rjminjectiontech.com/ for the harness and pins you need

If you splice the wiring, solder and heat shrink the splices. See http://fordfuelinjection.com/?p=7 for helpful instructions to do it the right way.


MASS air conversion instructions from http://www.stangnet.com/tech/maf/massairconversion.html

 

[Red88 RICK]

what harness do i need the whole thing or jus the mass air part?

 

[88mouse]

the only whole harness that you can use is an 89. I just spliced in the mass air part to mine. Its not hard just takes a little time.