Need measurements for GT/CS Hood scoop install!!

Discussion in '2005 - 2009 Specific Tech' started by NEFaurora, Jan 22, 2010.


  1. NEFaurora

    NEFaurora New Member

    Joined:
    Dec 27, 2009
    Messages:
    24
    Likes Received:
    0
    Trophy Points:
    0
    Subject: Need measurements for GT/CS Hood scoop install!!

    I bought a Ford Factory GT/CS hoodscoop and I need the install measurements, and I need the distance from the back of the rear hood lip to the back of the hoodscoop. The install instructions say the distance is from 8 inches to 8 1/2 inches. I'D LIKE TO GET AN ACCURATE MEASUREMENT FROM AN ACTUAL GT/CS CAR.

    Could someone please go out with a ruler or tape measure and measure the distance from the back of the hood to the back of where the rear part of the hoodscoop begins? It will only take two seconds...ok, maybe five seconds...lol.

    Please be as accurate as possible..

    Thanks!!

    Tony Kovar
    Melbourne, FL

    1966 Mustang Sprint I6 Convertible
    2007 Mustang V6 Convertible with Pony Package
    MCA#70001
    #1
  2. SpartaPerformance

    SpartaPerformance Site Sponsor

    Joined:
    Nov 5, 2006
    Messages:
    2,159
    Likes Received:
    24
    Trophy Points:
    49
    Location:
    Long Island NY
    That hood scoop is the same as the GT package hood scoop. If you open your hood and take the liner off you will see the dimples in the hood where the factory drills the holes you can use that as a template
    #2

Share This Page