So I finally finished the installation of the dual purge through my hood, I had so many complications to work through it was ridiculous. First I was sent a defective purge solenoid, then they didn't send me back my fittings when they sent me a new one (I sent the old one in with the fittings attached), then the fitting I bought so I didn't have to wait caused a nitrous blow back, then... blah blah blah. Anyways, it's finally done, and here's a little video of it. (As a sidenote, although I had some issues, CompCams, aka Zex, was extremely helpful and their shipping was lightning fast) http://www.youtube.com/watch?v=GHphpp49CSY
hmmm seems like a lot of work i would have brought them out the rear of the cowl because i wouldn't want to work that hard but it looks cool are you going to get the led kit down the road? i have never seen it and im trying to figure out if its rice lol
Nice...I was hoping on making a video like this yesterday but of course my line had to have a hole in it
I'm wondering how I feel about it too. I'm going to think it over for a while before I decide. I'm also wondering if it's worth all the extra work to mount two seperate LED's under the hood. Thanks for all the compliments guys!
hey...can you just send me some pics of the underside of your hood since I just want to see how I can upgrade my stuff since It isnt holding that good as of now.
At the advice of another member, I used aluminum tape to secure the line. While it may not be the most attractive solution it was very easy and works well. I'm not too concerned about what my engine bay and the underside of my hood look like, though a lot of other people are.
