One mans junk is......

[pabear89]

Ok, well its not a mustang but I thought that some would like to see my
10.00 body rotating holder.

This is what I have been doing with someones junk they were throwing out.
It started as a Camper stand and lifting jacks.

With some creative thoughts and the lack of funds to go out and buy one,
I did a Cheapie and Historic route.

I can turn the body with one hand and it makes working on it so much easier.

and it doesn't take too much away from the projects budget.

PB

I went and measured it, with about 25.00 worth of square tubing it can be made to hold a mustang body.
that will be handy for the next one.

 

[65stanger]

 

[bnickel]

waycool

 

[StangDreamin']

Cool!

So what kind of motor is going in the Heep?

 

[pabear89]

What it came with only reringed, bearings and timing set.
Daughtless 225 V6, Offy 360 dualport intake with 600 holley and longtube headers, Gm 1wire alt.
3sp t14
Has 67 corvette 4whl disc's for brakes.
I have added the Gm steering box set-up(more to come)

It's my attempt to recondition this 67 Cj5 for 2500.00
So with about 1100.00 spent to this point,

I need to be a little more creative.

 

[bnickel]

what size are those huge by wide's you have on there?

 

[pabear89]

Bfg's 33x12.5x15 May be a little big cause they rub on the springs in the front on tight turns.

But I am searching for a different offset of wheels for it now,
I kinda like the look......

It'll just make it float well in water.