Opinions- Water/meth Inj. Or Killer Chiller For Iat Cooling.

Discussion in 'SN95 4.6L Mustang Tech' started by jetmech807, May 29, 2014.

  1. jetmech807

    jetmech807 Mustang Master

    Joined:
    Dec 2, 2011
    Messages:
    1,819
    Likes Received:
    559
    Trophy Points:
    134
    Location:
    Las Vegas, NV
    I just came across the killer chiller. Since I live in the desert, I'm thinking the KC would be the better set up. With ambient air temp is usually 110+ in the summer I'm thinking this would be a great addition when i finally get all this installed. Thoughts? Anyone have any experience with one of these?
     
    #1
  2. Nightfire

    Nightfire Mustang Master

    Joined:
    Dec 2, 2002
    Messages:
    3,606
    Likes Received:
    134
    Trophy Points:
    93
    Location:
    TX
    Meth. Super cool IATs + 116 octane. Easier to install and maintain, only engages on WOT (where it matters)
     
    #2
  3. jetmech807

    jetmech807 Mustang Master

    Joined:
    Dec 2, 2011
    Messages:
    1,819
    Likes Received:
    559
    Trophy Points:
    134
    Location:
    Las Vegas, NV
    The KC does look like a bit of an octopus.
     
    #3
  4. Nightfire

    Nightfire Mustang Master

    Joined:
    Dec 2, 2002
    Messages:
    3,606
    Likes Received:
    134
    Trophy Points:
    93
    Location:
    TX
    Remember that the KC was specifically designed for the Air-to-water crowd where heat soak is an obvious problem. Us A2A guys don't have that problem.
     
    #4
  5. jetmech807

    jetmech807 Mustang Master

    Joined:
    Dec 2, 2011
    Messages:
    1,819
    Likes Received:
    559
    Trophy Points:
    134
    Location:
    Las Vegas, NV
    Well, being in the KB camp makes me an a2w guy. If I didn't live in the desert it wouldn't worry me so much. I'm tempted to go this route. Just more crap to add to the list, either way, I guess.
     
    #5

Share This Page