hey all. im geting ready to install a Maximum Motorsports Panhard Bar on my 98 GT. previously i had a FRPP diff girdle installed(the new style with FRPP insead of SVO on it). i know MM says the T/A ones clear the PHB. if im not mistaked the FRPP ones are made by T/A. can anyone verify this?
panhard bar and FRPP diff girdle
- Thread starter bdcardinal
- Start date
-
Sponsors (?)
Just spoke to MM about this not 2 day ago.
They said: If the 2 bolts for preloading the bearings are recessed into the diff. cover it will clear the PHB cross brace. If they are not recessed they could stick out too far and during bump travel could hit the brace.
Correct if I'm wrong but I think the ford racing cover has recessed bearing bolts, I havent seen one in while.
I have a PHB and I'm currently looking into the diff. covers, let me know if yours will work and I'll pick up the same one.
They said: If the 2 bolts for preloading the bearings are recessed into the diff. cover it will clear the PHB cross brace. If they are not recessed they could stick out too far and during bump travel could hit the brace.
Correct if I'm wrong but I think the ford racing cover has recessed bearing bolts, I havent seen one in while.
I have a PHB and I'm currently looking into the diff. covers, let me know if yours will work and I'll pick up the same one.
