Patriot Stage 2 heads

Discussion in 'Engine and Power Adder Parts' started by nickmckinney, Oct 22, 2009.


Thread Status:
Not open for further replies.
  1. nickmckinney

    nickmckinney Member

    Joined:
    Sep 25, 2009
    Messages:
    164
    Likes Received:
    0
    Trophy Points:
    16
    http://cgi.ebay.com/ebaymotors/ws/e...=110448621708&viewitem=&_trkparms=tab=Selling


    Starting bid is $995

    Last set on the shelf, we took a set of bare Patriot Stage 2 Romeo CNC heads and did the following:
    - installed our manganese bronze guides
    - installed Ferrea stainless steel valves in 1.78" intake and 1.45" exhaust diameters
    - installed TFS valve springs
    - installed our Viton valve seals that seal the valve stem to guide much better than the oem seals
    - CBN surfaced (mill) the head, intake, and exhaust gasket surfaces
    - Gave heads multi angle performance valve job

    Heads are assembled and ready to go with your cams, lifters, and rockers.
    #1
Thread Status:
Not open for further replies.

Share This Page