PMS - Switching between data sets?

Discussion in 'Fox 5.0 Mustang Tech' started by Metalcop, May 18, 2007.


  1. Metalcop

    Metalcop Active Member

    Joined:
    Jun 6, 2004
    Messages:
    149
    Likes Received:
    1
    Trophy Points:
    28
    Kind of a silly question, but how do you switch between data sets? I mean, I have programmed 2 of the three, and can manipulate the sets, but whenever I shut the car off, and turn it on, the main display screen always reads ds:1 , which indicated to me that I am in dataset 1. When I am editing each data set it clearly states ds:1, ds:2 etc, when in edit mode. I simply want to tell the PMS to use the data set of my choosing. Shouldn't it display ds:2 or whichever set I choose on the main display screen?? Thanks!
  2. PoonRacing

    PoonRacing Member

    Joined:
    Apr 1, 2003
    Messages:
    70
    Likes Received:
    0
    Trophy Points:
    7
    go to "options", on the page 2 "def data" change it to "2".
  3. Metalcop

    Metalcop Active Member

    Joined:
    Jun 6, 2004
    Messages:
    149
    Likes Received:
    1
    Trophy Points:
    28
    Thanks a million, it is not covered in the instruction manual, and I just couldn't figure it out for myself, duh!

Share This Page