Reattaching molding on door

Discussion in 'Fox 5.0 Mustang Tech' started by NOSNotch, Jan 2, 2004.


  1. NOSNotch

    NOSNotch Founding Member

    Joined:
    Oct 20, 2001
    Messages:
    581
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    South Jersey
    The front of the molding on the door of my 87 is starting to come loose. It's hanging out enough that when i open the door it gets caught on the fender so i want to reattach it somehow but I'd rather not pull the whole molding off. Any ideas on how to reattach it? I'm tryin to avoid just putting a flush screw in it (I know it's ghetto) but its startin to **** me off. Thanks for any advice

    Kevin
    #1
  2. jrichker

    jrichker StangNet's favorite TOOL SN Certified Technician Founding Member

    Joined:
    Mar 10, 2000
    Messages:
    21,701
    Likes Received:
    372
    Trophy Points:
    134
    Location:
    Dublin GA
    Two words... Super Glue...

    Just use a little acetone on a Q-tip to clean the area before you apply the super glue.
    #2

Share This Page