Whats up guys, I was wondering if anyone is running one of these ultra grip pullies on a S-Trim. They are pricey..but I'm in need of boost.
I run a 2.95/7.85 setup now...with a 7" crank waiting to go on.
I'm only seeing 9 or so #'s on a fully forged bottom end (not enough)
I only have minimal belt slippage so I don't wanna waste my cash.
I was thinking of going a tad smaller say 2.75 or something if I go with this pulley..I'm looking for 15#'s
I'm back in the states in 6 days so as Stiffler says
"It's on like Donkey Kong" ha ha
I run a 2.95/7.85 setup now...with a 7" crank waiting to go on.
I'm only seeing 9 or so #'s on a fully forged bottom end (not enough)
I only have minimal belt slippage so I don't wanna waste my cash.
I was thinking of going a tad smaller say 2.75 or something if I go with this pulley..I'm looking for 15#'s
I'm back in the states in 6 days so as Stiffler says
"It's on like Donkey Kong" ha ha