While playing around with my car, I noticed a real bad kink in the nylon part of this line, near the quick disconnect. I guess I know why, the disconnect is messed up and there's some copper type fitting (metal tube was cut, then put back together)...
Now I'm putting some stainless lines from the fuel lines to the rail. I got some nice Russel quick disconnect to 6 AN but now this broken line messed up my plan. What do you think I should do? I'm thinking adapting the metal (what is it 1/4") pipe to a AN fitting?
Pressure side looks fine though...
Now I'm putting some stainless lines from the fuel lines to the rail. I got some nice Russel quick disconnect to 6 AN but now this broken line messed up my plan. What do you think I should do? I'm thinking adapting the metal (what is it 1/4") pipe to a AN fitting?
Pressure side looks fine though...
