Well i got the adjustable guide plates on but could not get them lined up. When I torque the studs down the studs lean out throwing off the alignment. I think this is a case of crappy guide plates. I removed the plates and torqued the studs down. I slid the guide plates in over the push rods to see if the alignment was right and it was. If the studs would torque down straight over the plates I would not have an issue. Any suggjestions. 
P.S. I'm ordering a new set of isky adjustable plates in hoping this will fix the issue.
P.S. I'm ordering a new set of isky adjustable plates in hoping this will fix the issue.
