Anybody know where I can find Mach replica style rims in deep-dish from? Like say a 17X10.5 or 17X11? I want to run some wider rubber on the rear w/out changing the heritage of my Mach. Thanks. 
Stock Mach rims in deep-dish form!?
- Thread starter downsouthman1
- Start date
-
Sponsors (?)
LI98GTStang
Founding Member
JonJon
Founding Member
average guy
New Member
hobbes80
Founding Member
http://www.newstalgiawheel.com/listproducts.asp?cat=10115
They go all the way to 11"... but they are pricey and don't look exactly like your mach rims... they are the old school Magnum 500 rims
They go all the way to 11"... but they are pricey and don't look exactly like your mach rims... they are the old school Magnum 500 rims
stallion98gt
New Member
I'd like to go w/ the 01 Series Billet Cruzer in 17X8 form front for $425 each & 17X11 form rear $450 a pop. It'll look Mach-like but I think it'll lose some heritage. It'll certainly gain some appeal however. After the rims I'd probably lower the front like 1.5 inches w/ an Eibach Pro-Kit & add a Steeda ball joint for another 0.5 inch drop & do the rear by between 0.5 & 1 inch so I can avoid rubbing. I'm not quite prepared to dump $1750 just yet so I'll deliberate on these new findings for a while. Thanks for yalls help.average guy said:
Similar threads
