Bullitt Suframe connector's on bullitt, Mach 1, 99-04 cobras and conv.'s question?

Discussion in 'Special Production' started by ericmcn, May 23, 2010.

  1. ericmcn

    ericmcn Member

    Joined:
    May 21, 2010
    Messages:
    63
    Showcase:
    4
    Albums:
    1
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Outside of Tampa Fl.
    Hello, I have purahased through LRS the 2001 Bullitt subframe connector kit however, it has no insturctions lol. The front holes are already drilled and tapped in the frame from the factory. But the rear is not it has locking clamps to put on. I am eventually going to have them welded on but wondered if you guys have pic.'s or experience dealing with them that you can offer me so any advice or suggestions and pic.'s of them on you car would greatly help. Thank you.
     
    #1

Share This Page