Mach 1 Suframe connector's on bullitt, Mach 1, 99-04 cobras and conv.'s question?

Discussion in 'Special Production' started by ericmcn, May 23, 2010.


  1. ericmcn

    ericmcn Member

    Joined:
    May 21, 2010
    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Outside of Tampa Fl.
    Hello, I have purahased through LRS the 2001 Bullitt subframe connector kit however, it has no insturctions lol. The front holes are already drilled and tapped in the frame from the factory. But the rear is not it has locking clamps to put on. I am eventually going to have them welded on but wondered if you guys have pic.'s or experience dealing with them that you can offer me so any advice or suggestions and pic.'s of them on you car would greatly help. Thank you.
  2. wrif2049

    wrif2049 New Member

    Joined:
    May 24, 2010
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    USA
    I don't have them yet but my friend said his am with a template to drill d tap his bolt on connectors in.
  3. ericmcn

    ericmcn Member

    Joined:
    May 21, 2010
    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Outside of Tampa Fl.
    Thanks for the reply sounds like he has full lenghts, these are I guess what you can call shorty connectors. But the two front holes are pre drilled and tapped the rear has clamps that you slide in/on the back frame rail to mount them for this kind of connector. In another post I recieved a reply that told me bassicaly the Bullits/Mach 1s have the same clamps from the factory on their rear frame rail (they were switching to full lengths). But I think these since they are from Ford hold a more sentimental value then the other after markets personally I am a ford man and love frpp parts. Eventually I may switch to full lenthgs but for now this should do.

Share This Page