Things needed for t-56 swap in '01 Cobra

Discussion in 'SVT Forum' started by Iwvustang, Jul 14, 2005.

  1. Iwvustang Founding Member

    Member Since:
    Dec 12, 2001
    Message Count:
    226
    Likes Received:
    0
    Trophy Points:
    0
    I am going to be doing the t-56 swap in my '01 Cobra and need to know what needs to be done other than shortening the driveshaft and wiring up the reverse lockout. Can the stock clutch/clutch fork be used?
    Iwvustang, Jul 14, 2005
    #1

  2. wythors Get off my lawn!!!

    Member Since:
    May 17, 2000
    Message Count:
    2,410
    Likes Received:
    18
    Trophy Points:
    58
    wythors, Jul 14, 2005
    #2

  3. Iwvustang Founding Member

    Member Since:
    Dec 12, 2001
    Message Count:
    226
    Likes Received:
    0
    Trophy Points:
    0
    Yea, I already have the tranny & bellhousing. I just need to know what I have to do, if anything, other than shorten the driveshaft and set up the reverse lockout switch. I was planning on using my stock clutch, ect as I am pretty much broke after buying the T56. :damnit: Will this work?
    Iwvustang, Jul 14, 2005
    #3

Share This Page