Timing Problem

Discussion in 'Fox 5.0 Tuning' started by jeffbigwood27, Sep 1, 2006.

  1. jeffbigwood27 New Member

    Member Since:
    Nov 11, 2003
    Message Count:
    90
    Likes Received:
    0
    Trophy Points:
    0
    I set my timing at 10 base with the spout out and checked it a day later and it was at 4 with the spout out. Any one ever had this problem? And the dist was tight it wasnt moving around.

    Thanks,
    Jeff
    jeffbigwood27, Sep 1, 2006
    #1

  2. 68stang351 Founding Member

    Member Since:
    May 17, 2002
    Message Count:
    1,854
    Likes Received:
    4
    Trophy Points:
    38
    Sometimes the outer part of the balancer slips around the inside part if the rubber layer in between is too wore out, this could affect what your timing marks are showing your light.

    I don't know if that's whats wrong, just a thought.
    68stang351, Sep 4, 2006
    #2

  3. thunderstang302 New Member

    Member Since:
    Aug 2, 2009
    Message Count:
    3
    Likes Received:
    0
    Trophy Points:
    0
    the gear or the pin on the the distributor could be worn out
    thunderstang302, Aug 2, 2009
    #3

  4. StangGT1995 have car, will race....wait, it doesn't run

    Member Since:
    Oct 23, 2004
    Message Count:
    5,294
    Likes Received:
    4
    Trophy Points:
    88
    This thread is from 2006! :bang:
    StangGT1995, Aug 2, 2009
    #4

Share This Page