Two Step W/cop Conversion?

Thread starter Cupples981
Start date Jan 30, 2014

Cupples981

New Member

Jan 30, 2014

#1

I am planning on installing a Pi engine, complete with cams and cop coils on my 97 gt. I intend on keeping my original ECM. If I get a cop conversion harness will I be able to use a two step? It seems like this msd controller will work with the harness, but then again I may be wrong. Any ideas?? :shrug:

:shrug:

Msd two step I'm looking at getting-
http://www.americanmuscle.com/msd-launch-master-2step-9910gt-install.html

Sponsors (?)

Show hidden low quality content

You must log in or register to reply here.

Similar threads

Electrical tachometer conversion from 6 to 8 cylinder (will also work for 4 to 6 or 4 to 8 but with different resistor size)

Replies: 5

Views: 2K

1974 - 1978 Mustang II Talk & Tech Oct 31, 2022

Engine CRANK NO START

Replies: 2

Views: 941

1994 - 1995 Specific Tech Mar 21, 2022

1991 5.0 with HCI - started car, running for a few minutes, started pushing coolant into the overflow tank and then puking out from there. I'm lost

Replies: 6

Views: 2K

Fox 5.0 Mustang Tech Nov 30, 2022

Team-Z Setup in 1990 Mustang GT

Replies: 14

Views: 2K

1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 19, 2022

Spent 3 hours trying to figure out converting my jelly jar M/C to a dual reservoir M/C on my a-code '65 disc/drum

Replies: 17

Views: 2K

1965 - 1973 Classic Mustangs -General/Talk- Nov 19, 2023