What timining adjuster works with march piggyback pullies without stock crank pulley

Discussion in 'SN95 4.6L Mustang' started by cobras4every2k, Jul 29, 2004.

  1. cobras4every2k New Member

    Member Since:
    Feb 5, 2004
    Message Count:
    29
    Likes Received:
    0
    Trophy Points:
    0
    I'm running march pullies, without the stock crankshaft pulley installed. I did install the march crank pulley. These were piggybacks but so far no problems after 6,000 miles or so. Will the steeda t/a or upr t/a work with this setup? thanks for any asssitance.
    cobras4every2k, Jul 29, 2004
    #1

  2. kboy262 Active Member

    Member Since:
    Apr 20, 2003
    Message Count:
    442
    Likes Received:
    0
    Trophy Points:
    26
    I don't see you having any problems since you are not using the pulley for the crank. If you are using the stock crank pulley the Steeda time adjuster would work fine.
    kboy262, Jul 29, 2004
    #2

  3. Tylerb59 Banned

    Member Since:
    Mar 7, 2003
    Message Count:
    1,920
    Likes Received:
    0
    Trophy Points:
    0
    Personally save your pennies and buy a Diablo Predator or even better a SCT.

    Either way, you can control your timing through the ECU / Tune.
    Tylerb59, Jul 29, 2004
    #3

  4. bowens99GT Founding Member

    Member Since:
    Aug 27, 2002
    Message Count:
    658
    Likes Received:
    0
    Trophy Points:
    0
    I'd much rather use a timing adjuster than a chip. I have the SCT and dont like it very much. Shifts at 3200rpms at normal driving. Not the best for the money to me.
    bowens99GT, Jul 29, 2004
    #4

Share This Page