will a 302 (5.0) bolt up to our stock transmission

Discussion in 'SN95 V6 Mustang Tech' started by Riceforlunch, Dec 27, 2003.

  1. Riceforlunch

    Founding Member

    Joined:
    Apr 19, 2002
    Messages:
    135
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    SC
    Thinking about doind an engine swap.
     
    #1
  2. SpectorV

    Founding Member

    Joined:
    Sep 3, 2000
    Messages:
    1,871
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Florence, Alabama
    they will bolt up to the stock T-5 tranny i dont know about the AODE....
     
    #2
  3. BABstangV6

    BABstangV6 Smater than the average bear!

    Joined:
    Apr 3, 2003
    Messages:
    607
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Rock Hill, SC
    Yeah, but our transmission has some parts that are smaller then the 5.0's. I cant remember the specific parts inside the transmission sorry.
     
    #3
  4. SpectorV

    Founding Member

    Joined:
    Sep 3, 2000
    Messages:
    1,871
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Florence, Alabama
    the trannys are all the same, we have the same oen used in all the 5.0 v8s ect the only diff is teh gearing and they beefed up the T-5 a couple diff times, we have the strongest i am sure.

    you may need a new bellhousing and this and that
     
    #4
  5. Riceforlunch

    Founding Member

    Joined:
    Apr 19, 2002
    Messages:
    135
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    SC
    so all i need is the engine, rear end and im set
     
    #5
  6. SpectorV

    Founding Member

    Joined:
    Sep 3, 2000
    Messages:
    1,871
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Florence, Alabama
    bell housing, clutch, cable, computer, k member, rear end, and a BUNCH of other parts.
     
    #6
  7. 98v6mustang

    Founding Member

    Joined:
    Aug 21, 2002
    Messages:
    313
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Jane Lew / Fairmont WV
    i'm pretty sure there is a difference in the length of the input shafts on the t5's

    the 5.0 t5 has a shorter input shaft, therefore has a different bellhousing
     
    #7
  8. bgjohnson

    Founding Member

    Joined:
    Sep 2, 2002
    Messages:
    965
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    johnston,iowa
    why don't you just buy a GT. unless it would be a for learning purpose.
     
    #8

Share This Page