Will these bad ass rims fit

[91Moostang]

I am going to do a 5 lug conversion to my 91 notch w/sn95 spindals and ranger,bronco,aerostar axles in the back. Do you guys think I have enough room to stuff these rims in there.

http://cgi.ebay.com/ebaymotors/18-9...43958QQitemZ8029873775QQrdZ1#ebayphotohosting

what do you think.

 

[87Saleen#166]

9" is too wide for the front. and the rear will stick out .5" even with ranger axles.

they won't tuck, sorry

 

[1SLO306]

9" will fit on the front. and u could get 10" to work on the back with modifying.

http://forums.stangnet.com/showthread.php?t=523399&highlight=deep+dish

 

[jimsstang91]

yes it wll work. i have a 91 notch and i have 10.5 deep dish. take out quad shocks, roll lips, bash inner fender, 1/2 spacer. done.

 

[mob]

yes they will fit, i run 9" on the front everyday with minimal rubbing, its fine, and 10" will work on the back, find out the back spacing though that will be the deciding factor, with 5" backspacing i fit 10" wheels with 315 tires WITHOUT removing the quads and no modifying, and NO rubbing, it will work if the backspacing is right.

 

[fiveohwblow]

I run 9's on the front and back lowered 2 inches with no problems at all!

 

[Tonys96Cobra]

I couldnt see the offset for them, but I am assuming that the front is 24, if so theyll fit no prob. CHeck out the white notch on this page, he has an almost identical setup..

http://www.corral.net/forums/showthread.php?t=748835

 

[Blakthorn]

do they sell those pony center caps seperate somewhere?

 

[srothfuss]

Black - you can get pony centers from a lot of different places. CJ Pony parts cataloge for example has the 3-bar running pony centers for $24.95 IIRC.

 

[ironmedic]

no spinners? u need spinners dude