WTB 9" 28 Spline Posi Center Section

Discussion in 'Engine and Power Adder' started by Johnny Ray, Mar 9, 2006.


  1. Johnny Ray

    Johnny Ray Founding Member

    Joined:
    Oct 4, 2000
    Messages:
    255
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Pekin, IL
    I have been looking round for a 9" 28 spline Posi Center Section with no luck and was wondering if anyone just might have a setup like that for me?

    Gear ratios anywhere from 3.00-4.88 would be OK.

    Thanks!
     
    #1
  2. justford

    justford Founding Member

    Joined:
    Feb 16, 2001
    Messages:
    67
    Likes Received:
    0
    Trophy Points:
    7
    Location:
    Grayson KY
    I have one on here for sale. It is a complete assembly from backing plate to backing plate all new with axles, brgs. and etc. Look at the ad. Will sell as a complete assembly only. Here is the link to my ad. Remember all the parts are new, even the posi unit.http://forums.stangnet.com/showthread.php?t=617604
    Thanks
     
    #2
  3. Edbert

    Edbert Founding Member

    Joined:
    Jul 14, 2002
    Messages:
    3,445
    Likes Received:
    1
    Trophy Points:
    59
    Location:
    Austin TX
    Johhny, just my $0.02 here, but I'd be leery of buying a used Posi/LSD. They wear out over time and even if they are working when you buy them you never really know how much life they have left in them. Lockers I'd say the same, but to a MUCH lesser extent.

    If I were you I'd look for a used open diff to save money, they are probably under $50 for a complete center (open/28s). Then you can install a fresh/new posi/LSD into it and have the peace of mind.
     
    #3

Share This Page