Wtt/wtb: Valve Cover Studs (have Studs For Tall Covers, Need Two For Short)

Discussion in 'Engine and Power Adder' started by MeanMussy, Jun 10, 2012.

  1. MeanMussy

    Founding Member

    May 25, 2000
    Likes Received:
    Trophy Points:
    Louisville, KY
    No longer needed.

    Well, I started out thinking I was going to use the "tall" Trick Flow valve covers, so I bought the stud kit for those way back when. Decided to go with the "short" valve covers instead. So, I need two more of the short studs, and have two of the long studs that I don't need. I'm hoping that someone out there is either in the opposite situation as me, or happens to have a couple of these laying around.

    It's not the end of the world if I have to run a bolt into one hole on each side, but it would be nice to be consistent with the studs. If anyone needs the two studs for the tall valve covers and wants to trade, or if anyone has a couple of the short studs and want's a couple of bucks for them, let me know.


Share This Page