347 stroker

Status
Not open for further replies.

itsaMustangtoo

New Member
Apr 2, 2005
292
0
0
Carlisle,Pa
I am looking to put my mexican blocked 347 stroker in this winter. Therefore the stroker I am currently running is up for sale. Can hear run. I need to make some room in the garage. Please contact me if interested. I need to get about $2600.00 out of it. The motor only has about 1500 miles on it. That is about half the price of stokers I have seen for sale elsewhere. E-mail me @ [email protected] for more info.
 
  • Sponsors (?)


The kit has Kieth black Silvolite pistons. If it does intersect it is very minimal. I do so remember ,however that there were 3 oil control rings for added stability. I hope this answers your question. I could find the part #for the pistons. The kit was purchased and the engine was built 2 yrs ago.
 
Using a 5.315" rod, with a 1.175" piston combo allows the wrist pin NOT to intersect the oil ringland.

Using a 5.400" rod, with a 1.090" piston combo allows the wrist pin to intersect.

The latter, has an oil ring support ring added to the regular two oil rings and the oil spacer.
 
Using a 5.315" rod, with a 1.175" piston combo allows the wrist pin NOT to intersect the oil ringland.

Using a 5.400" rod, with a 1.090" piston combo allows the wrist pin to intersect.

The latter, has an oil ring support ring added to the regular two oil rings and the oil spacer.

There you have it. Both of my strokers have 5.400 rods. Thanks for the info. No problems to date .:nice:
 
Status
Not open for further replies.