I took the little stops out, and then made those holes slightly bigger to fit the rod part in there. ONce thats bolted down, take some toothpaste and put it on the tip of each rod. Then slowly close your hood until it makes contact. Then take a small drill bit and drill a hole there. Then make a larger hole until the rod fits through that part of the hood. The hole can be quite a bit bigger the the rod because the stainless steel things will cover them. ONce you get through the bottom of the hood do the same thing with the toothpaste and the small drill bit. Thing is, once you take those stops out, the hood wont be adjusted in there right, I have yet to make a system that allows the stops and the hood pins to work.