Separate names with a comma.
i've had to tweek my h pipe before,
just pull it back out and set 1 side on the ground, with your foot holding it on the ground just push or pull...
If you need a hand droping it in give me a ring.
I believe Mustangsunlimited also sells sn95 seat upholstery. Unfortunately They only sell leather. and no seat foam either. And the leather kit...
have you tried to pull any codes?
have you ck'd you fuel pressure with and without vac hose attached?
probably the pip inside the dizzy.
If you compare the left scoop to the right. you'll notice a differance.
Most likely the body shop only replaced the door and didn't mess with the...
FIRST pull codes.
what is your timing set at? 10* btdc is stock timing but you can get more pwr. by advancing the timing to about 14* but then...
if the compressor cycles then the ccrm is fine.
the reason it cycles is because it is still low on 134.
the low pressure sw is kicking the...
he replaced the dizzy.
are you getting fuel to the engine? what pressure?
have you ck'd fuses in passenger compt. and under hood?
Make sure the sunvisor lights, trunk, hood, glove box lights, etc. are not staying on.
at least you were smart enough to drop the tank before you fired it back up.
a tank left partially filled for long periods will form condensation on the inside from temp changes. condensation forms rust, rust turns to muk.
As a temp fix I use heat shrink tubing.
It worked for a single break but I think you need total replacement
for your fogs to work the head lights need to be on.
And the bulbs might be bad in the fogs too. I have a bad ground or a loose wire of one of...
ps. MSD means May Suddenly Die. A lot of people have had problems with the msd dizzy's. Have a known good back up just in case.
if it's vibrating sitting still, look at the harmonic balancer. with the engine running, the hb might be wobbling. with the engine off, look from...
couple of ways
With motor running- look at HB and see wobbling (how I found mine)
With motor off- from the ground looking up, look for rubber...
I'm thinking that with B/C springs having only a 1" drop CC plates would not be needed.
and B springs being progressive rate the ride should be...
it's the harmonic balancer
stop driving it till you get it replaced!!! bad things can happen
oh yea welcome to the site
also for the people with B or C springs, what is the amount of drop? The Ford Racing site says less that an inch front and rear. I'd just like...