Search results

please excuse my ignorance but I,m installing a LeCarra steering wheel on my 66 coupe.I placed in the 2 cancellation pins in the 2 holes near the center of the adapter. 2 questions- 1-how far do they project out and 2-(more importantly)-where do I place the pins in relationship to the turning...

no #'s on connector Suki243-there are no numbers stamped on the connector. Do you have a picture or diagram or can you desribe the location of the #s? Thank you-Tom

Suki243-Thanx for the info-very helpful! Tom

I'm at my wit's end trying to figure this out and I really need some help. I put in a painless rewire(20120) in the car and I am connecting the 2 harnesses (2 wire and 6 wire) to the male counterparts on the steering column.When I put the car in start,and turn the directional lever(up or down)-I...

sometimes the shifter is "sloppy" and won't engage the neutral safety switch in P. you can replace the worn bushings(there are 2) to tighten up the shifter-pretty easy to do

Check that battery has full voltage and that there is no corrosion on the terminals. Play with the shifter(automatic?) in P and N to see if the neutral safety switch might be the culprit.

check this out it's for a Ford falcon(similar chassis)-has a part list http://xanthe.lunarpages.com/~nkfalc2/restoration/T5.htm

check this out http://home.bresnan.net/~dazed/e-brake

thank you-Az Pete and Tim65GT both are you were very helpful! Great forum and great people!

does anyone know the continuity between the different male connectors(D1,P etc) on the headlight switch particularly when the switch is pulled halfway out to light the parking lights only? The reason is is that I had a painless performance rewiring kit(20120) installed and when I put the switch...

manual choke Manual choke is the way to go! You don't have to rely on heating an electric element or using hot air to expand a spring.You have 100% control on how much or how little to open the choke and when you want you can completely open the choke.I'va always installed manual chokes on my...

Try this web site http://www.mustangmonthly.com/howto/41438/

TRY http://www.moderndriveline.com/ http://www.darkhorseperformance.com/ to start:)

WOW! What a great forum!

I'm in the process of swapping a C4 to a T5z in my '66 Mustang(v8).I have A T5 bellhousing and T5 motor plate.I don't have any of the old bolts so I can't figure out the following: 1--does the motor plate require any bolts and if so,what length/width/pitch bolts and where do I place them...

Does anyone have a good diagram of the T5z tranni which labels all the parts.I'm trying to find the neutral safety switch,backuplight switch, the plug that fills it up and the drain plug and what's the black ball on top of the tranni for? Also what's the best way to add the fluid wnen the tranni...

Thank you LMan Thanx a lot-You are the "MAN"---LMan

Does anyone have actual pictures of this swap-No where on the web has a DETAILED step by step installation directions for a classic Mustang(later years-they have detailed instructions).Does anyone have pictures and detailed information of this swap that they did themselves and documented the...

Hello everyone,I'm new to the forum and I am thinking about doing this swap. I need all the help, and pictures also,if possible, in all the steps envolved in this swap. Any or all help will be greatly appreciated! Thanx Tom