Search results

95 mustang T-5 Bellhousing $65 95 mustang sway bar with bushings $65. 95 mustang fuel rails $70 95 mustang air box $45.00 95 mustang radiator plastic $35 95 mustang ccrm $45 Gt40 Phenolic spacer $30 Fox 70mm BBK Throttle Body $80 Pro-M intake tube $30 Mustang ½” – 20 x 3” , .615 dia...

What is the rev. limiter set at?? thanks, Jeff

Isn't the stock pump 110?? Thanks for the info!

I have a 95 mustang 5 speed with 75K miles, & the following mods: Edelbrock intake underdrive pulleys 70 mm TB cold air intake smog pump delete exhaust (from the factory manifolds back) Alum. Drive shaft 4.10 gears Boxed control arms Holley 155 fuel pump I plan to install the NOS...

My 95 with bfg drag radials.

Just wanted to know what a used set of GT40 Y heads are worth. I can probably pick up a used set for about $450, but I don't know what they typically sell for. Jeff

thanks,

I'm getting ready to do an intake swap on my 95 so.... The other day I went to purchase intake gaskets and noticed that the gaskets have EGR holes in them. Is this correct? :shrug: I could be wrong, but I thought our cars didn't have exhaust gases running throught the intake. Do ya'll...

Someone correct me if I'm wrong, but I believe the drivers side valve cover will fit, the passanger side will not because the oil fill tube on the fox cover is located a few inches further to the rear than ours. This will interfere with our throttle body. Jeff

Thanks for the info. I'll just purchase a new regulator.

Just want to know if FOX fuel rails will work on my 95. I just purchased a used intake with injectors and AFPR from a 91. It would be nice to save some cash on a AFPR if the FOX rails will work. thanks,

thanks I'll give it a try

Has anyone used the EGR eliminator/simulator found on ebay? see website http://cgi.ebay.com/ebaymotors/87-95-FORD-MUSTANG-5-0-EGR-ELIMINATOR-SIMULATOR_W0QQcmdZViewItemQQcategoryZ33553QQihZ020QQitemZ300180527864QQrdZ1QQsspagenameZWDVW I just purchased an intake and TB off a fox and I plan...

I was assuming about 3 tenths, I just didn't know how realistic that was. Jeff

I currently have 3.08 gears in my 95, 5 speed 5.0. My best quarter mile time so far has been a 14.13 @ 98 mph. I have a set of 4.10 gears that I would like to install, but I just wanted to know what quarter mile time I may expect to see with this gear change? Current Mods. Drag Radials...

I looking to purchase a new set of rims for my 95. I would like 18's maybe 9" fronts and 10" rears. I am looking for ideas, please post pictures. I would like to get something that is not very common. I thought about the ruff racing model 278's, but i'm not sure how they would look on my car???

From the og racing web site, The SFI Foundation, Inc. (SFI) is a non-profit organization established to issue and administer standards (or specifications) for specialty/performance automotive and racing equipment, with the goal of promoting quality and reliability in the design, manufacture...

Get this, I put the key in the on position, and started wiggling the wiring harness under the hood. Nothing happened. Then i took the kick panel off to expose the computer, and moved the wiring harness around, and then the fuel pump kicked on. I started the car, and moved the wires...

Hissin, (used battery as my ground) 5. - No voltage when the key is turned on. 15. - 4.8 ohms 13 - 0 volts 24 - 2.04 Volts 8,10,11 - All have battery power 11.8 Volts 18- not showing anything as soon as the key is on, nothing at all from this one.

For what it worth, I just used a noid light and got nothing. Earlier i tested the coil (with a volt meter) & injectors (with a test light) using the battery as ground, and then jumping across both terminals, and in both cases, got nothing. I checked the fuses yesterday, and all looked...