Search results

I am assuming by "HU" you mean the receiver? I did pull the battery, it reset the clock but made no difference to the phone display. It is an 06, with 20,000 miles on it, I can't see anything needing replacement. Any other ideas?

As of a couple days ago, my audio receiver says "Phone" and will not play audio. I cannot switch it from this. I tried pulling the battery but when I plug it back in, the same message appears. Any advice? Thanks, Jayson

Basically I don't do any auto-cross racing, I rarely go to the strip, so the pads I need are for daily use.

Quick Question - What are the best brake pads for a stock 2003 cobra? Mine are starting to whine a lot and are getting pretty annoying. I was looking at these.... 1994-2004 Mustang Cobra, Bullitt, and Mach 1Hawk High Performance Street Front Brake Pads at AmericanMuscle.com - Free...

thanks. that worked.

The ignition is locked so I cant turn the key. There have been no issues as of late.

I'm in a parking lot right now in my 2003 GT and when I try to turn the key in the ignition, it doesn't turn and the "theft" light is flashing. It flashes about every second. I had the tuner plugged in but it didn't show any codes because I can't turn the ignition. Any ideas of what is wrong...

No accidents or anything. Below is its history: 01/07/2003 NICB Vehicle manufactured and shipped to original dealer 02/04/2003 Indiana Motor Vehicle Dept. Scottsburg, IN Registered as personal vehicle 02/11/2003 15 Indiana Motor Vehicle Dept...

Ok, I will do that then. Thanks! Jayson

Does anyone have the tune for me to put in? I have the tuner and hopefully could put those numbers in until I get to the tuner (1 week later) after doing the swap. If that's a no-go, I assume it is incredibly easy to swap and could probably do it at the tuner, with the puller.

Buy an 03 10th anniversary! Only 2003 made!

After switching the pulley to a 2.81 is a tune required immediately? If so, does anyone know the air/fuel ratio needed so I can at least drive it for a few weeks before having it professionally tuned?

The yolk is broken so it makes a really loud bang whenever I turn. I did end up getting them to replace the drive shaft and also replacing my flywheel.

Exactly, I didn't see that you could change the model.

Wait, disregard the entire post. I need education on how to use the internets. You can select on that site what model you have. Does anyone have any pictures of the cobra striped?

Am I retarded? Why can I not find them on there?

Anyone know where I can by stripes for the 03 Cobra. I can't seem to find any on the internets.

Yeah, they said that it wouldn't be under warranty. I thought it was complete crap, I just wanted to make sure before I laid my foot down.

Woot... I am going to buy me some blinker fluid and an o-pipe too, eh :canada:

Sorry, I meant driveshaft. What are these muffler bearings you speak of? Do they go on top of the muffler or inside them? If I change them could I see an increase in HP?