Search results

As the subject says.... ? I have two of these 285/40/17 tires sitting in my garage... Anyone know if I can get these mounted on the stock 17X8 split 5 spokes wheels? I know they fit 17X9's... but will they fit with an inch less width? Its an odd tire, so Im not sure if anyone here has...

Hey all, I bought a Non-H.O. engine to replace my worn out 247,000 mile shortblock. I am putting a new set of E7's onto my new shortblock instead of retaining the slack-ass E5's. Its a Lincoln roller 5.0. I know it doesn't have the H.O. camshaft, but I have one laying around and thought about...

Classifieds!!!!!! Here on StangNet.com! I bought them for 200 plus shipping. I was actually looking for leather, but it was a helluva deal, so i scooped it. ~Joey

I recently put the 02' GT seats into my 89' Coupe. Not hard by any means. I used the 02' tracks and they bolted up with no modifications. They sit about an inch higher, but with all the power hooked up, you can adjust it easily. As far as power goes... The 02' seats use a 4 prong adapter...

If the tranny isn't going in, its the pilot bearing holding it out. Take another look at your input shafts!! The previous tranny should have a thin input shaft. Your new tranny probably has the V8 shaft. I ran into this problem also. Had to find a 4cyl. tranny. 4cyl. transmissions will slide...

FUEL PUMP!!!!!!!! I am going to say this is your problem. I had the SAME EXACT problem and came to find only 9psi of fuel going to my rails. Replaced it with a 255lph intank. Fixed. Let us know what your cure is! ~Joey