Search results

DiMora's Steeda G-Trac brace installation Here is an easy, cheap mod. The 2005-2006 S197's did not come with any sort of brace between the back of the front control arm bolts...and from what I understand this can lead to some flexxing while cornering. Some of the road-racers on other...

Pop the Hood. Remove the only two screws that hold in the passenger side plastic grill just below the passenger side windshield. This is the piece you are removing. See the two holes? Lift grill straight up. You have to be careful on the center part (windshield wiper is in the way...

Kenne Bell or Roush TVS. I went Roush TVS because I got a good deal. I love it. With a TVS, you will still need a Kenne Bell Boost-A-Pump (just like the KB uses). You will also need a custom snout pulley to lower your boost so you don't blow up your engine. As others stated, the KB...

I concur, Steeda CAI.

I know you decided already... I was considering the Roush P-51 clutch when my stocker gets destroyed by my supercharger. Stage 3 Motorsports 2005-09 Mustang GT Roush P51 Clutch Assembly

Yes indeed! :nice:

As many of you have seen in my TVS upgrade thread, I recently installed a TVS blower in place of my M90. My car's internals are not forged, and therefore I was afraid to run the TVS as it comes out of the box. The "box" setup includes a 3" diameter blower snout pulley, as well as an...

Sure can. Go crazy! :flag:

I agree 100%. For all out 700/800 HP and up...I would go with that giant Whipple...then the KB mammoth...the TVS would be out of the running. There is even an article in one of my Mustang mags this month where a guy had a gT500 and he put in a TVS then ripped it out and added the giant...

Bingo.:nice:

I thought I would be happy with the high 300's / low 400's as well...but now I am used to it and I WANT MORE! So I know if I go to 450-460, I will get used to that as well and want more. I have a superbike that lays down high 160's to the rear wheel, and I know what it was like every step...

Also, the new TechCo blower appears to be awesome. It is pricey, though at $7500 I believe. I would avoid the Edelbrock like the bubonic plague until they get t sorted. :D

Saleen makes nice blowers, no doubt about that. The reason I suggested Roush TVS, Whipple, and Kenne Bell is future upgrade ability. If you are wired like I am...whatever power you make is never enough...so if you go with the three I mentioned you can later forge your internals (crank...

So what was the final resolution of this?

Check your owners manual for the interval...but I am going to do it once every spring after pine pollen season ends. :nice:

Pop the Hood. Remove the only two screws that hold in the passenger side plastic grill just below the passenger side windshield. This is the piece you are removing. See the two holes? Lift grill straight up. You have to be careful on the center part (windshield wiper is in the way...

Steeda mounts and Tokico D-Spec shocks are what I would do. And get a new torque wrench.

Put a Whipple High output on it at 10PSI and blow it up. Put a Roush 445 on it and make 360-400 RWHP. Put a Kenne Bell or Roush TVS or whipple with an appropriate pulley on it and you can make 400-450 -600+ RWHP, enjoy it, and have room to grow. Do your homework, find a good tuner, and...

I pulled the center / radio console trim and tapped into the wiring where the existing cigarette lighter is. While I was there i went ahead and added a Honda S-2000 Start button for some bling gadgetry.

I can't answer the tune question, but performance wise, they would do absolutely nothing. Your car's computer is striving for an air/fuel ratio (using the Mass Air Flow (MAF) Sensor and the Oxygen sensors)...if the stock injectors can make that ratio - you are all set. Oversize injectors...