Search results

  1. M

    Driverside Sparkplugs WTF? with pics

    The Answer: You can not use the rubber End Seals that come with the Fel Pro kit. When you are using milled/decked heads. And its a good idea to use MR. Gasket ultra seal intake gaskets not "stock" fel pro.
  2. M

    Driverside Sparkplugs WTF? with pics

    I just did a TOP end rebuild a month ago. All new gaskets, heads decked 30 with 1011-1 gaskets.No check engine light, but i know that does not mean there are not codes, i will check.
  3. M

    Driverside Sparkplugs WTF? with pics

    I looked up the chart FIRST.
  4. M

    Driverside Sparkplugs WTF? with pics

    Driver side spark plugs WTF? They are about a month old, and only the driver side is like that. The pass is normal..
  5. M

    Rev Limiter/IGN problem MAYBE?

    Topend change after bad head gasket. I was shifting a 5500 before the swap, no problems then. (Is the stock rev limit set at 6200?) Now after the build, the rev limiter/ign/fuel seems to be coming on at 5500. The car runs GREAT, no miss, no valve train noise, nothing... ANY IDEAS??? New...
  6. M

    Clutch masters question

    STAGE 2 or 3 puck style VS Dual Friction clutch sets. Come with your experiences, taste and bang for the buck. 90GT gears 3.23 few bolt on's 100 shot
  7. M

    Car PULLS after brake job.

    Cool thanks bro. Im all over it sat morning, if you think of anything else LMK im at work till 10:30 tonight.
  8. M

    Car PULLS after brake job.

    Ya the torque is right. If i take the tire off i should be able to slide the caliper inboad or outboard? How much? And if it does not move?
  9. M

    Car PULLS after brake job.

    90 GT 5 speed. I did a brake job last week(pads and rotors). Did the driver side first, and then the pass. And now the car pulls to the driver side.(was not pulling before) If I jack the car up the pass side wheel/tire turns about 2 or 3 revolutions, the driver turns maybe 1 revolution...
  10. M

    Smog delete

    X2 .... new belt route... if you have stock pulleys AZone 860k6 or after market small pulleys 845k6:nice:
  11. M

    Nitrous: nozzle or TB plate

    I have been looking for a wet nitrous plate for my stock 5.0 intake(between the upper & lower) NOS disontinued just the plate. So my question: nozzle or TB plate? Im looking for the most efficient, better atomization, brands.....thanks BKD