Search results

I just picked up a 97 Cobra earlier this summer with 42lb. inj., Vortech V1 supercharger , forged internals. Im having a issue with the idle hanging a little bit so , in the process of checking out vacuum lines I noticed the vacuum line that runs to the top of the Vortech FMU isnt hooked to...

wont the pistons have to be notched to use GT40 or GT40P's ??

Any help with this would be appreciated. The passenger side power window stopped working, it wont go up or down. I checked via test light, that I have power going into the switch. I have power coming out of the switch at that plug. I put power from the battery to the power window motor plug and...

Does anyone have a troubleshooting/testing procedure for the MAF Sensor. I have a a 86 LX thats been converted over to mass. Thanks......

Thanks for the reply on this. I didnt do the mass conversion on the car. The previous owner did. Thats been a portion of my problem with troubleshooting anything on this car. It seems like Im always trying to figure out what he did and why he did it that way. I wasnt aware of holding in the...

I have a 86LX converted to mass.Cobra upper and lower,b303,BBK CAI,headers,smog stuff removed and alot of other smaller add ons. I started the car to take to work yesterday morning and it all of the sudden was running rich with no power at all. The night before it ran great. I pulled a code...

I was wondering is there any way I can visually tell if my car has underdrive pulleys installed ? All these pulleys look alike to me. Thanks.....

Im going to be buying heads relatively soon and Im not sure what way to go, any opinions would be appreciated. The car has the following add ons. 1986 Mustang LX Cobra intake. B303 cam. Mass Air Conversion. B&K CAI. B&K Headers. MDS Ignition module. Timing bumped up 13% 24lb...

Im doing a differential swap next weekend on my 86lx. Ive noticed on the rear that I will be putting in on the top of the differential there is a vent hole. It was covered with a rubber yellow cap. I looked into the hole and you can see the axle. I realize this is a air vent so the rear...

Ive read a few post on here and other places about blocking off the IAC with a plate to address a idle issue. My question is, what are the pros and cons of doing this ? Ive been chasing a idle issue for a few months now and was wondering if this should be a option for me at somepoint.

Thanks for all the replies on this. My motor mounts arent the best but, until I can get them changed I was looking for a temporary fix for the CAI. I wanted to make sure I wasnt alone in my thought about cutting some of the pipe off to make more clearance. Thanks...

I just installed a BBK fender CAI kit in my car. No matter how I shift it around or angle the tubes I cant seem to get the tube that goes from the MAF sensor to the throttle body intake to stop rubbing off the front strut tower. There seems to be about a 1/8 inch of clearance between the...

Aftermarket. I did not realize this was normal. Very interesting.

I just installed a BBK Cold Air Intake (fender kit) . The previous intake was a March Ram Air that a previous owner had installed. The March kit was below the bumper and was all busted up when I purchased the car so, I decided to change it out. Anyway, now that the BBK is installed I seem to...