Search results

Does anybody know of any well written books.Or youtube videos that kinda shows how to assemble the interior.Dash and trim, seats.Any advice I would really apperciate.

I tried to sell the cobra a few months back.Plan being to put a down payment on a newer front engine rear wheel or 4 whell drive car.I was trying to get 4 grand for a car that made 424 hp and 470 ftlbs at the rear wheels.No buys here in san diego CA cause the car won't pass smog. List of mods...

I'm going to go with the AAW harness I think cause I read a bunch of reviews and saw that for the most part its the same as the painless.But 50 bucks cheaper.Also I'll probably lose the FI and go carb.I plan to use the car mostly for driving I dunno 4 days out of the week.And drag and autocross...

This is the donor car

Hey thanks for the replys.Also just got my project a few days ago.

Does anybody know if I can use my disc brakes on the 69?

Its the push rod 5.0 stroked to 331

Thanks for the reply.Can I use my wiring harness to plug up the tail lights also?

I have a 1994 mustang cobra with a vortec V-2 si supercharged 331 motor.With a built T-5 trans.I picked the 94 for the 5.0 and T5 which I knew would swap over to 1st gen mustangs.And now I've bouht a 1969 mustang with a super clean and straight body.And want to know what parts I can use.The 69...

It looks tight.And it is.I said befor I'd suggest the fox body swap.But I wanted to prove it could be done.I'm running the vortech v2 si with a 3inch pulley.Once I get it all working and tuned I'll decide if it was a waste of time.But 67 degrees in the intake when its 80 degrees out side is...

Late picture of intercooler set up.When we had it on the dyno the air temp didn't go over 67 degrees.And we haven't hooked up the water pump yet.But when we do we will run ice in it and then tune it.

Do you have under the hood parts?I'm looking for the fuel lines from the passanger side of the motor.Fuel rails to firewall.Email me at [email protected] if you can help me out.

How do I post a picture?Because this is ugly and I'm sure people will get a laugh out of how I did it.And now I under stand why its better to just do the fox body mustang then the intercooler install.

So I have a 331 stroker with a vortech s/c.And I've painstakingly installed a water to air intercooler.I couldn't find an install so I figured it out my self:nonono:.So now I need help installing my eletric water pump.I took my a/c pump off.And tried to use the electric current from that and it...

Stroker kit switch to long tubes windage tray and crank scraper.Lose your mufflers and cats if you still have them.I think a big wet cheater shot of nos would be the cheapest way.

I bought an act clutch FM4-HDSS - ACT Heavy-Duty Clutch Kits because it was suggested by a ford mechanic.I only have 100 miles on it so far but the clutch feel is lighter then the king cobra was.Also the king cobra clutch was still good when it was pulled from the car.So I was over powering...

I have a 94 mustang cobra just up graded to a V-2 si trim vortech supercharger,Edel brock intake and 40lb injectors.So now my king cobra clutch wont hold and is pretty much done.So big question what kinda clutch should I look in to anybody have any ideas?Had the car on a dino but the dino wasn't...

I have a 94 mustang cobra just up graded to a V-2 si trim vortech supercharger,Edel brock intake and 40lb injectors.So now my king cobra clutch wont hold and is pretty much done.So big question what kinda clutch should I look in to anybody have any ideas?Had the car on a dino but the dino wasn't...