Search results

bump

Four fox body 15" x 7" 10 hole polished 4 lug wheels for sale - $400 Four Mustang 15" x 7" 10 hole 4 lug aluminum wheels for sale - polished I have a set of four 4 lug 8” x 15” 10 hole original equipment Mustang aluminum wheels, with tires, for sale. These are off of my 1985 Mustang GT. I...

Sold. Thanks Joey

Thanks

I did the '94'04 Cobra 5 lug front brake swap onto my '85 GT last week. Now I need to convert the rear end to 5 lug. I have an 8.8" rear end with the '88 Thunderbird turbo coupe 4 lug rear disc brake set up with 10" rotors. Once I get the new 5 lug axles, what rotors do I use, or will I...

I have a complete '87-'93 front spindle, 11" rotor setup with the giant 73mm piston Lincoln brake calipers, new ceramic brake pads, and caliper brake lines to the hard lines at the body. The spindles and calipers have been zinc coated for corrosion protection. These were a giant improvment...

OK, after my original post I went back out and looked at the tops of the struts. I have caster plates that are about 3/4" off the top of the strut tower, and another 3/4" spacer on top of that, at the top of the strut rod, under the attachment nut. I noticed that the '94 spindles dont reach...

I am doing this conversion this morning and I have a problem. I am finding that the 2 mounting holes for the spindle to strut conection are about 1 to1.5" apart. Cant get them to come together. If I put a jack under the control arm, the whole car goes up, and the holes stay the same...

Can someone post a link to the instructions for this job. I havnt found one here.

Is this easy or a big job?? The shop manual doesnt tell just where its at or how to change it out.

Thanks

Or do I have no choice but to replace the hub/bearing assembly?

Thanks. Yes, doing it for '98 cobra calipers and rotors. The '98 spindles push the wheels out, and I may have clearance problems if I use those.

Can anyone tell me if my wheels will be further out in the wheel well with '94 spindles over the '86-'93 spindles that are on my '85 now? If so, how much further out?

Thanks for the help!

Does anyone know how much wider the track will be? with the '94 spindles, over the '86-'93 spindles that are on the car now. The outside edge of my front tires are right at the fender lip now, with no contact. I have the Cobra brake caliper set up off of a '98. What brake lines do I use to...

One of the '98 steering arms is straight, and the other is curved. Both of the spindles that are supposed to be '94's have the curved arms though. Thanks

I have a pair of spindles that I believe are off a '98 cobra. PN's F6Z8FA & F5Z7AA cast into the spindles. I bought a pair of spindles that are supposed to be off a '94 or '95. PN's F4Z7AA & F4Z8AA cast into the spindles. I am putting the spindles onto my '85 GT and need to be sure that...

Can anyone help with that?

I have an '85 GT with the '86-'93 8.8" rear axle. I need a pair of 5 lug axle shafts. When I look at what there is available, there are different axle spline counts and I dont know which one I should be buying. Can someone help me with this please.