Search results

if you want to make power here is your cam http://mrnormsgarage.com/parts/mustang-parts/mph-kenne-bell-2-valve-cam-s.html These are the cams I am running I laid down 561 RWHP on bone stock heads with these cams on an AUTOMATIC.. would have easily been over 600RWHP on a 5 speed. I have a setup...

You can remove your front bumper and mount it inside the bumper it fits very well there. I had mine installed there then moved it to the trunk. be sure you mount you tank higher then your pump due to the pump being a pusher pump. it is easier to mount it in the wheel well in the trunk, then...

I am running the Victor JR EFI, and just recently did a EGR delete. I made my own EGR delete plate, and went to lowes for the Cap to cap off my header pipe. It is really easy and straight forward. You can buy this kit, or put together your own. there are a few vaccum lines you will have to move...

For sale is a used vortech 6 rib 2.62 pulley. 50$ shipped

Injecting water onto the MAF will cause huge problems, the car will start stalling, and running very rough, general rule of thumb stay upstream of you maf atleast 12" so you dont get blow back onto the MAF sensor, you need to mount your METH nozzle as close to the TB as possible, I have also...

Sounds like you have already replaced the engine wince you have a Windsor Block in there, the windsor has an 8 bolt crank which is debatably a little tougher then the romeo. If you want to spray you will be safe up to 125 shot, with colder plugs, fuel safety switch, and a good tune. I sprayed...

Yes sounds like the clutch is out of adjustment. Where does the pedal start to grab? this will determine which direction to go with your adjustment.

He everyone, I am from Tennessee, Not new to the Mustang scence, but new to this site. I have 2 mustangs one is my 88 5.0 Fox body, and a 2000 Mustang Gt convertible. I enjoy being able to help people with thier mustang issues, and also receive help. I look forward to being a contributing...

A good used supercharger setup will compliment your car.

What is your goal with your car? did something mechanically go wrong with your heads? if you are just looking for power if so you will spend more on a new set of heads then you will on a good used blower kit for your car. As far as heads Trick flow has a quality Complete top end kit for your...

What do you have to spend? you may look into a new short block, and new PI heads or have your heads reworked you can do all of this for well under 5000.

If you do a cam job on top of purchasing the used engine you can add atleast 500-600 for cams 200 or so for new springs, plus labor to install which will add up to well over 1000. Is this your daily driver? upgrading to the Cobra setup is going to cost you upwards of 7000 that is if you can...