Search results

hahaha I know 24's don't make horse power! the guy who built this setup I guess thought that way. the TB has been changed and I think the piece the MAF attaches to is bigger than 55mm. everyone says spend the money and get a calibrated MAF I've read they aren't accurate. this is my first...

see I have the A9l bin definitions and I think im going to change the injector high and low slopes. but if I change them will the MAF be telling the computer to open injectors like 4.5ms which the MAF thinks it has 19's and be running rich because it has 24's cause 4.5ms is 4.5ms but the...

well one of my friends recommended moates, and tuner pro rt? I bought the car from a guy who used it for drag racing, I drove it home with slicks on the rear. when I started driving it I knew that it had a lot of blow by, and had 24lb injectors in it. then I looked at the MAF and saw the part...

ive upgraded to 24lb injectors, still have stock 55mm MAF. I am trying to tune the fuel slopes and stuff to make it right for the new injectors, I am wondering with the stock MAF do I need to change the voltage readings so I get a decent A/F ratio. I do not have data logging capabilities so I...

Did some research and jegs offers two starters for my 88 one is 3/8 in depth and another is 3/4 in depth. So I went to two parts stores and what do you know they only offer the 3/4 depth one. So i looked older and for an 82 they offer a 3/4 depth for a/t and 3/8 depth for m/t

Ok the starter drive went out and I replaced the drive and I think its gunna happen again, summit told me it was thetway it was bolted in but there's only two holes, then one of my friends said I need a 10 tooth drive. I don't know what tranny the guy put in there, prolly a. T5 every time I...

Well i did alot of resistance checks and voltage drops in school, and reading some books that i got from there. My friend at autozone let me borrow a reman computer and to me that fixed it. but in a few days if it does the same thing i got a guy in ga that will send me a wiring harness. Cus...

Testing sti to ground i got 0ohms next is zero and the 46to40 and 60 say not a complete circuit

I will surely do that in the morning! I do understand how it works, ford didnt have the best in computers in obd1. And speacialy when a dumb guy who brakes a intake bolt, switches from speed density to mass air, puts stock 50 plugs in gt40 heads

I did the test procedure like you stated and looked in book, my test light turns on when keys off but when you turn the koeo nothing koer same thing. But i tested maf i got a ref of 12,volts and injectors are pulsing so how can computer be bad? I was thinking of putting fuel pump on a 20 amp switch

It happens when its warm, yea it does have the conversion although idk if its done right, mod inside the engine idk, outside, holley upper and lower cold air intake. Yes i have seems fine to me id say the plug looks like its burning fine.

Ok i bought a 88, it was misfiring when i bought it but i knew what it was, but now it lacks power. He had 24lb injectors on it but i swapped those to 19 because i think it flooded it. Driving maybe 30 mins and then shut off, when you go to start it again it wouldnt start. Had 38lbs of FP and i...