Search results

I have a complete power disc brake setup including but not limited to: booster and master cylinder, proportioning valve, lines, spindles, rotors, calipers, bearings, flex lines, fittings. All is there and all would require rebuild. Asking $450.

Well I've continued looking at pumps on the internet and have a new question. What is the saginaw pump pressure that I should be looking for. I know I said earlier that I've read you should be looking for around 1000 psi but all the pumps say for their description is not a pressure rating but...

My pump isn't good and would need replacing anyways which is why I'm looking at getting a GM pump. The water pump on my windsor is different mounting bolt location for P/S pump bracket so I would have to modify my existing modified bracket to adapt to the GM P/S bracket. If the GM pump is a...

I'm looking to do a borgeson steering box swap on my 68 xr7. I'm trying to save a few bucks and possibly buy the pump from somewhere else for a little cheaper. Does anyone have a part number that is the correct pump for completing this swap? I've read that this is a common pump for GM...

Looking to hook up the A/C again in my 68 cougar xr7 while converting to a modern sanden compressor with R134A refrigerant. No, it's not a mustang but anyone who's a mustang guy, shouldn't have a problem. My question is which compressor should I buy? I've been looking at Sanden compressors...

Planning on heading back out to the garage so I'm eager to hear from you.

Hey all, I ordered some parts from Summit including oil pan gasket, intake gasket, and two new lifters. BUT, I decided to review the noise one more time before tearing off the intake and replacing the lifters and really searched the block to locate the noise. The strongest spot that I've...

No, I don't believe it's oil pan. The motor never had this noise on initial build and nothing has changed.

The eagle I beam stroker kit that I purchased did not require notching on the 72 block. Had I gotten H beam rods then there would be notching done. I am a little weary of either a wrist pin or lifter being bad. But with the noise getting less noticable as the engine warms; does that make...

What would be a possible diagnosis of a noise that starts strong and goes weak as the motor warms up? Also, would a spun main bearing make a knocking sound or would there be a different noise. Also the motor has only about 500 miles on it since the fresh bore and hone with the installation of...

I have a motor knock that I can't diagnose and neither can a few friends and family. The knock is worse on start up and is less of a noise as the engine warms up. It seems like the strongest noise is on cylinder number 5. The motor is a 72 351 windsor that's stroked to 408. I pulled the...