Search results

Just drained the oil last night, it was brown. However, I had thought that some residual coolant might have not completely drained before re seating my lower intake (correctly) after the last leak. Prior to draining the oil I checked the dipstick and the oil was significantly clearer than it...

I have rebuilt the top end of my moter after a blown head gasket. however, I still get water coming out of the tailpipe for my 5678 cylinders. I have pressure tested my cooling systems no leaks at all and have done compression checks and all cylinder are showing 150PSI. I am on a 2nd set of...

The back of the cam has the following "1207" Additionally, its hard to read but it looks like "123"

Greetings I was wondering if I could get some help identifying my cam. It has the ZE code next to the first lobe however, I'm not sure whether it's a ford racing cam or stock. I measured the lobe height and it comes out to 1.72" and width of 1.46. I understand the formula is (height - width)...

Thanks a lot for your help

I measured the lifter at its base height .3" and at its top .6" subtracted the base from the top so .3" lift? I am taking these measurements from the top of the lifter NOT the base cup of the lifter. I understand the lift of the stock ho cam for a 93 is .278? I would assume this would then be...

Greetings Does the stock ho cam have any numbers for identification? I purchased my car slightly modified and the seller did not know if the cam was aftermarket or stock. Is degreeing a cam the only way to identify it?

Greetings I am installing the Trickflows spring replacement kit (part number 2500100). The supplied seat retainer gauge the gap height is 1.8" and trickflow requires the springs to be installed with a +.015 shim which equals 1.8 +.015. My question is, 1 of my exhaust ports is .030 short...

I've assisted friends with a some work on the top end of engines such as blown head gasket etc. It is my first time going this far into an engine though (replacing cam and listers) I just figured with the change in the lifters, more pressure higher revs stronger springs would affect the...

Would I have to worry about these backing out considering the roller cam setup and no poly locks?

Greetings New Foxbody owner with a question. I am attempting to convert my convert my engine to a roller motor with using a mild stage 1 cam or the ford x cam. I've looked at the tfs springs TFS-2500100 http://www.summitracing.com/parts/TFS-2500100 as replacement springs however, my question...