Search results

I know I end up asking a lot of questions but I have done some research on the K member I would like to install. Its the MM KMember but my issue is that with the matching tublar lower control arms the cars front wheels get moved over 3/4s of an inch. Is there a Kmember/lower control arm combo...

Racecraft is the only company I can find with spindles

The point for the spindles is to make sure that the lower control arm and the tie rod stay parallel with one another so that the front suspension swings on the same arc. Is there any other drop spindle options besides racecraft. I am thinking of not doing two inch drop just due to speed bumps...

Well I have come to a issue. The MM Kmember and lower control arm combo adds 3/4s of an inch to the wheel base measurement. Is there any combo out there that will not adjust my stock wheel base measurement?

I am doing research on what I want to do with my rustang. I have decided to start with the suspension and brakes first then go from there. I have been looking into aftermarket from suspension systems and subframe upgrades. There are three that have really sparked my interest and I need help on...

I wanna drop my car two inches. I know there is a lot of options when it comes to Lowering Springs but I don't want to mess up the front end geometry. I have been looking into Drop Spindles for the nose and Drop Springs for the rear. Are there any good Spindles out there that can handle street...

here is an update. The plug was melted but the fan was toasted. I purchased a new fan and the car runs great. The only negative is I was sitting in a parking lot and it didn't over heat but the cap popped again. I didn't loose much fluid cause I shut the car off before I made to much of a mess...

there are no fenders in the scrapyards here in Southern Indiana. If you plan to pass through this area then we can meet up!

i think is it. I did the MAX AC to try and get the fan to kick on and it didnt. So my next move wash to hook 12V directly to the fan harness and attemot both speeds. If I remember low spd didnt spin and high spd pulsed and slowed to a crawl might be the other way but either way one spd wasnt...

I know I have been making a lot of posts, sorry! I am lookingfor a driver front fender. I will go aftermarket if need be but I want an OE fender for my 02. I hit adeer a few weeks ago and have the car almost pieced back together. I still drive it but it looks funny without a LF fender but I...

Alright man! Thanks

I doubt its air cause this has happened twice in about 1 1/2 months. The car temp is fine at constant speeds. Both times it happened I was sitting still. She runs like a champ any other time.

so i took my stang off ramps today to drive around. I had been driving for about a half hour (city). We stopped for about 5 minutes when we heard a pop and saw white smoke. I looked at the temp guage and it wasnt anywhere near the hot mark. After it cooled I checked and all the hoses were fine...

not a k member.

I have an 02 Mustang GT. I hit a deer the other day and while making repairs noticed what looks to be a crossmember under the car that is bent. It is under the bellhousing. The trans doesn't connect to it. It just connects the L&R frame rails together. The part # ID is 5B112. I need another one...