Search results

  1. Valnar300

    Clutch Release Issue

    Yesterday I was driving home on the freeway (stop and go) in my 02 GT with a Spec stage 1 and Steeda Quadrant, when all of the sudden my clutch stopped releasing. i limped it down the freeway in 1st until the traffic cleared up then drove home. (Thank god I used to drive an old VW so I know how...
  2. Valnar300

    Tweeter Question

    This might be stupid to ask, but I have the Mach door corner tweeters in my car, and no sound is coming from them. I bought the car from the PO with an aftermarket stereo in it. My question is this: how do I find which wires are for the tweeters and how do I hook them back up to work properly?
  3. Valnar300

    Internal Problems, should i sell the stang?

    Mine acts like va01gtstang does. anybody ever figure out what it is/was?
  4. Valnar300

    Drivetrain Cant Shift

    Yup drives like new! And the pedal is much softer now that I went from Stage 2 to Stage 1.
  5. Valnar300

    Drivetrain Cant Shift

    That and a seized pilot bearing and grumbly TO bearing. I think it was the pilot that was causing the trand to not wind down until it was forced
  6. Valnar300

    Drivetrain Cant Shift

    And I just got it to work again :/ I started it, then put the shifter up against 4th, where it was grinding, it wound down on grinding, and then it went into 4th, and every other gear. How utterly bizzare. Thank god I'm getting a fat bonus soon, so I can buy a new tranny
  7. Valnar300

    Drivetrain Cant Shift

    He cut me off and stopped short, I slammed on the brakes, and then went around him. I forgot to downshift from third and burnt the clutch pulling past him.
  8. Valnar300

    Drivetrain Cant Shift

    OK, so I burned the clutch a bit yesterday because some jackass cut me off, and Then I couldn't shift into any gear, as I was rolling. I had to force it pretty hard, but no grinding or anything like that, and it went into gear and as I was driving home it felt fine again. This morning I cant...
  9. Valnar300

    Passenger Floor Wet

    If I get a coat hanger and squeeze my arm in the engine bay I can barely get down near it. Not a whole lot of space to get to it.
  10. Valnar300

    Passenger Floor Wet

    There is a drain, but every time I clear it it works for a day or two at most.
  11. Valnar300

    Passenger Floor Wet

    Heater core is solid, and I still havent had time/ambition to pull the dash out yet. So far I'm dealing with it by using a towel to soak up the condensation whenever I use the AC.
  12. Valnar300

    Passenger Floor Wet

    OK, I've got water coming in from the AC, its not draining through the firewall like it should. I've already unclogged it with a coat hangar and blew it out with air. That fixed it for a little bit, but now its clogged again. Is there any way to access the drain from the HVAC box side so I could...
  13. Valnar300

    I Think I Broke It

    I'll get it on the rack at work tomorrow and take a closer look. its really unnerving though.
  14. Valnar300

    I Think I Broke It

    I think I broke the mustang (02 GT, manual trans)... Put the new tires on today (274/40/17 from 245/45/17) and after taking a left on the way home I heard a violent clank/clunk noise from the rear. It sounds/feels like the LR tire when it happens, and tends to happen accelerating around corners...
  15. Valnar300

    New To Mustangs From Socal

    And here's a pic of my ride
  16. Valnar300

    New To Mustangs From Socal

    Hi all, I'm new to mustangs and just got my first one about a month ago. Its a 2002 Mustang GT, 128,xxx miles, with a Magnaflow exhaust, Mach 1 trans (manual of course), 3.73 gears I believe, and a Diablo tune. I got it for 3k off a buddy and used to drive a 40 year old bug, so all in all not...