Search results

Well, it wasn't that low, but barely any was on the stick. I imagine the transmission being on it's way out now after 20 some years is not uncommon, so I am saving up to have it serviced (rebuilt or replaced, probably rebuilt cause $$$)

So OP what did you end up doing?

Is the wiring thing the alternator check? I haven't looked at it other than that I've been busy with school and work. I figured out it's the transmission, if I turn off overdrive it works fine. So I checked the fluid and it was a little low, added fluid and now it is running fine. I will have...

if you have the money, get the top installed professionally.

*bump*

it's a 1995 v6, I tried the test and never got a negative reading, it was also 14.5-6 volts no matter if the lights and fan were on, or the radio. Revving it also made no difference. I don't know if they do since I think it had these codes for awhile, but it really only started to get driven a...

Ok these are what I got with my cheapo obd reader: p0174 System Too Lean P1151 P1150 P3150 P0340 Camshaft Position Sensor "A" Circuit

Oh and after that it stays at 2000rpms. Is my transmission out or something? I hope not :/

so I have seen a lot of threads about cars with low RPMs not accelerating and it is usually the Catalytic converter from what I have seen. But my car gets to 55mph fine, but after that the rpms go back down to what it has during idle, around 700-1000. If I floor it, it takes a second or too...

Alright thanks, need to get this replaced ASAP!

View: http://imgur.com/a/aOdfO

I checked it and it is melted, so I just need this switch then? The connector is a little melted will this matter much? the connector doesn't move it is just the housing.

Just to make sure, it's the pull out knob by the defrost button right? I'll take a closer look today

What would be the fix with this? do they sell that whole assembly or is the CB separate? I'll take a look at it more thoroughly today

I didn't unplug them, just looked at them plugged in, but I looked at both. They were on hi beams, after that i put them on low and it didn't happen again. I tried using hi beams again and they switched off, so i kept them on low after that. So only high beams on make it do it and I haven't...

I was driving back home last night from a relatives house and the lights just completely turned off. The dash was still on though, and after I tried turning my brights on and off it came back on. I got home and could not reproduce it anymore, but it did happen once again, After that I kept my...

holy necro, side note, when this happened to mine it was easier to get the whole steeringwheel assembly from another car because we didn't have any idea how to fix the damn thing

Old thread but question, if I can jump the low-pressure switch and the compressor comes on it is either freon or the switch is bad correct? What is the right psi for the freon? Thanks!

Hi y'all, So I have a 1995 convertible that needs a new top and also busted a cylinder. Pulled one from the junkyard and now need to install it and the lines since it messed up one of the connectors. How do I fill this thing back up? Should I pull some fluid into the cylinder before installing...

okay it definitely is that. What size hoses does it use? the one that goes towards the engine is dry rotted so bad it isn't even a hose anymore. Do they go bad usually? If it isn't too expensive I'll just replace it