Search results

PM Sent

$1900 shipped with 80mm PRO-M and MSD 6AL or will do $2100 shipped adding in the Snow Boost Cooler Stage 2 (boost dependent) and the safe injection module.

$2100 shipped with Pro_M 80mm Mass air and MSD6AL

$250 OBO

I purchased this kit a few years ago for my supercharger project but never installed it. It is brand new in the box and still has the plastic around it. I have instructions for them both. New they run for $560 for both. Looking for $250 OBO plus the ride. Have photos if needed...

$2200 shipped

For sale is a new Vortech V2SQ Kit 4FG218-020SQ that I bought a few years back. It is still in the original box and plastic. This kit inclused the Vortech BTM, water pump and crank pulleys, T-Rex in line, Vortech FMU and all hardware for to mount on supercharger up. The head unit is still in...

These are the non emissions heads?

PM me if you decide to sell the intake seperate

Thanks for the information on the issues you had. I think I am going to just get the shortblock all ready put together so i don't have to due the conversion. I can do the install of most bolts on, but don't think I have enough knowledge to deal with the conversion and any problems that may...

$375

I have decent mechanical skills and I had a buddy of mine with me who builds race cars and it took us about 8 hours (it took a little longer then he usually does because he was showing me how to do it). One thing I would do differently is look up the sizes of the nuts and bolts and have all...

There is a 69 block for sale that has been magniflux, sonic check, and hot tanked. I was wondering if the 69 blocks are worth the extra work that goes into them to convert to a roller cam. I appreciate any input.

Thanks for the replies. This is going to be primarily a street car. My target area is 550rwhp and something that is able to drive on the street. It will see the track a few times to see what it can do but other then that, I will drive it in the spring through fall as a weekend car. (probably...

Hey guys, I am going to start to gather all the parts that I am going to be putting on for a re-build. I was thinking of going with a Dart based 331 or a production 351w with a 408w stroker. I know it costs money to convert over to the 351w which is why I am not going with the Dart for the...

I am planning on re-doing the whole car and am set on setting a 351 (stroked to either 393 or 408). I will put AFR heads on it, a Trick Flow Series R, and a custom cam backed by a Lentech Street Terminator Plus. I was thinking about throwing the S-Trim on the motor but do not want to get too...

Hey, wondering if any of you guys were going down to the NMRA's this weekend at Atco. Does anyone know what Vendors/tuners are going to be there?

I have a 2006 Mustang GT and was looking at blowers to put it on. Being that it only have 4000 miles on it, I don't want to slap the blower on and then throw a rod. What would it cost to have the engine rebuilt? I know the kits for the rods, crank and pistons go for about 2K to 2.5K, but what...

Right now the distributor is sitting in at direclty 0*. I personally was not doing the timing on the car (family friend does a lot of motor building so he was doing the timing). The fuel pressure we set down to 38. I was thinking about swapping back to the 24lbs injectors. I am just...

I did a heads and cam swap on my 95GT and the car won't start or idle. If we play with the timing alot the car will start up but we have to keep it up to 4-5 rpm to keep it running at all. The car is running really rough like it has a Extremely radical cam in it and it will stall out the...