Search results

  1. 9

    8.8 Ring and Pinion 373 with install kit

    @GrnLantern Sent you message.
  2. 9

    8.8 Ring and Pinion 373 with install kit

    I have a brand new 373 gear set purchased from Summit never been out of the box. Bought it a few years ago and just never put it in the car. I also have the install kit http://www.summitracing.com/parts/FMS-M-4210-C/. $220 for both and I'll throw in a Summit hat buyer pays shipping. Located...
  3. 9

    Fuel pump won't prime

    If the pump wasn't getting return pressure wouldn't that cause it to keep running?
  4. 9

    Fuel pump won't prime

    I should explain better. Normally turn key on pump runs for 2-5 secs then stops. I'm calling that primed. In my case this does not happen it just runs unless I try to start it. If I try to start the car it will fail to start and when I stop turning it over the pump will not be running.
  5. 9

    Fuel pump won't prime

    Been away from the forum for awhile so I'm not up on the lasted posts, but having some fuel problems. I have a 92 fox body gt with ford racing gt40. Fuel pump runs and I have pressure around 42 psi, but it just runs and runs like is never gets primed. There is an air pressure sound along the...
  6. 9

    whats slowing me down?

    ok man sounds good i've already got a pump and tb coming figured what the hell might as well have them. wanting to add a supercharger in the near future anyway. i did find that the timing was off 8* so i set it at 14*. did seem to help my low end. any other suggestions? I also need to get...
  7. 9

    whats slowing me down?

    yes with this install intake was the only thing i installed. how likely is it that i'm starving it of fuel with a stock pump? and not aod its a 5 spd
  8. 9

    whats slowing me down?

    I have a Pro M already
  9. 9

    whats slowing me down?

    Fuel pressure is at about 39 and timing I need to recheck, but was at 14*.
  10. 9

    whats slowing me down?

    I'm wondering were I'm loosing the most power in my setup. I have a GT-40 crate motor with the B303. I have a TFS track heat intake,80mm MAF,24lb injectors,kirban fuel pressure reg. Just installed the intake and I'm not feeling nearly the power gain I expected. I know my stock fuel pump and...
  11. 9

    Backfiring/Hesitation/Powerloss

    Not to sound stupid bud, but how are you setting the timing. Pulling the jumper and then setting? Just a shot
  12. 9

    hey, i'm new.....got a question

    You probably need a gasket for you spacer. I would just bypass the spacer, pull the hoses off it a get a piece of pipe and hook them together. That will take care of it, the spacer is the only thing near the TB that would have antifreeze flowing in it.
  13. 9

    hey, i'm new.....got a question

    Well I hate to say but it sounds like you either cross threaded the plug or its not tight and the liquid i'd say gas. Your TB is leaking or the TB spacer in front of it ? The spacer has 2 pipes that come out and a rubber hose on each side on each of the pipes and anti-freeze runs through the...
  14. 9

    Q for speaker gurus

    What kind of car are you putting these speakers in? www.crutchfield.com go there and find out what fits your car. There prices are high so I personally would order else where. But i'll give you an idea of what would fit.
  15. 9

    the guy at best buy told me to....

    Depends alot on how much you want to spend. I'd say the setup your thinging about will work just fine and probably sound good. Depending on how much bass you want a mono amp might be a better choice than 2 channel for your sub or subs. check out www.etronics.com great prices on car audio and...
  16. 9

    [B]Tips on wetsanding and buffing[/B]

    yea i'd agree try buffing it a mild cutting agent would probably bring it back.
  17. 9

    Best way to spend 3 grand on motor???

    i was thinking about a short block 5.8 mustangs unlimited has one for 1800 bucks rated at 385 hp. anybody think this would be an ok choice? set of heads and intake would put me at 3200 i'm guessing what else am i missing? if i rebuild i'd be hoping for around 350 to 400 horse all motor and in...
  18. 9

    Best way to spend 3 grand on motor???

    i'm going to rebuild or buy an engine for my 92 gt and i wanna spend around 3000 bucks just wondering if i should rebuild or just buy something. i have stock 302 with 155000 miles on it.counting in machine work i was wondering if buying an engine would be smart. just looking for a lil advice...
  19. 9

    Fog Light Problem!!!!!!HELP!!!

    Ok on my 92 GT I have one fog light the works just fine, but one doesn't always work. once in a while it will work. So yea I know the bulb is good, would a bad switch cause this? :shrug:
  20. 9

    Window bushings won't fit!!!

    hey all got some window bushings for my 92 gt from 50resto and they won't fit has anyone else had this problem? Customer service handle the problem awesome and i'll order from them again for sure. for one because they credited my account the price of the bushings.