Search results

THANKS !

bump ! if you come you'll have a blast ! this will be my 3rd year of going and helping .

if thats too high , try x2c ... they have some nice looking parts also , heard they do good . but think of this , you get what you pay for .

i run a 28x12.5 on a 10in wheel . running a 302 with nitrous i can cut 60ft's in the mid 1.3's all day long , (with a footbrake) also drag radials work great too . i've cut high 1.5 60ft's with a 275/60 bfg on a 8in wheel , or high 1.4's with a 325/50 on a 10in wheel . good luck , and have...

(www.teamzmotorsports.net) check out daves parts .

thank you .... i will try this . i have done it ether way in the past . in the air and with a load on it . (never had a problem ) first time for everthing . but as for the adjustable arms ... if you put then at the same lenght as *(stock)* your not using them for what there made for :D...

while it was in the air . i've always done this . all i can think of is i put the spacers back in on the wrong side where the contol arm bolts to the torque box . (i droped the whole rear out of the car when i replaced the bushings .) i'm running double adjustable uppers and lowers , and...

i'd think this too ! but i'm running a 8in wheel with 5.5 backspacing and running a 275/60 15 , which cleared fine before the bushings ... now it hits on the drivers side ....

i'm a ford man .... but i have helped do this swap more than a few times ... all you have too do is make spacers for your mounts . (square tube works great )(i like to use a motor plate ) stock trans crossmember work too. headers ...look for any year camaro header .. ! they all work ...

just put new bushings in my rearend housing ... now my drivers side tire rubs on the inside . and of course there is more clearance on the other side . how do i make this right ? have i got the bushings in too far or not enuff on one side or the other ? or would it besomething else ? nothing...

i've run sothsides , (work very good , but very hard on car ) bennet , double adjustable uppers and lowers , (great and easy on car , but there is a learning curve to make them work ) teamzmotorsports , can't say much about the best parts out there .... best looking , best made ...