Search results

your fuel sending unit is bad, and you need to replace it, new for about $80-$115 bucks, or pull it out and fix it with a sealant if your low on cash, but you'll probably have to pull it again earlier down the road. By the way, its the other hole on the gas tank next to the fuel pump! comes...

Yeah, my buddys car does the same thing with his conversion? It idles but it jumps up and down, but stays running that way! But it also doesnt do anything different when you unplug the mass air meter, and no check engine light either??? But I noticed if you put you hand over the intake pipe and...

How do you get computer code out without using a diagnostic computer tester? I know you can do it but i never had a problem with my check engine light. Does anybody know, and also know where to get the codes and numbers for fox bodies? thanks...

How exactly do you hook up the gauge to the o2 sensor??? Does anybody know which wire it is that you hook it up to? Because my gauge hops up and down and doesnt show it running rich at all even though its supposed to when its cold, right... But does anybody know exactly what wire it is and how...

yeah i changed the injectors to 24s because my buddy had a problem with his 19s cracking, so i made sure to upgrade. But the car runs good it just had a little hesitation at low rpm, and its running on the lean side so i know there has to be a leak coming from somewhere? I just gotta find it...

Hey thanks for the diagram, yeah not only was the trick flow intake alot different than the stock intake as far as vacuum routing goes, i still dont know if i got it right or not, but i had to use all the old hoses, so im thinkin it might just be an old hose leaking but i checked and they seem...

Does anybody have the vacuum diagram for the fox bodies? or anybody know where i can buy the replacement hosing for all the vacuum lines, because i have a leak somewhere and i cant seem to find the damn thing, the hosing is original and has lots of cracks. Anybody know what the most comin place...

I have 3 Chamber Flows with dumps, and their pretty quiet for the most part, until you really get on it. Not loud in the cab either, because the sound is directed to the ground and angle out. 2 chambers are alot louder!

ok, i have 2 fuel pressure gauges. One BBK mechanical gauge on the fuel rail, and an AutoMeter Electronic Gauge in the car. The AutoMeter Gauge always shows about 5 psi lower than the BBK gauge under the hood. No matter if I disconnect the vacuum line or not. Now the BBK should be most accurate...