Search results

  1. whtpny

    Fox Body "Convertible" Top Speed ???

    More than we should drive on the roads!!!
  2. whtpny

    Replaced speedo cable still bouncing

    What did the speedo gear look like? Maybe that is shot.
  3. whtpny

    Ignition help

    Yes, The stock ignition can not handle the cylinder pressure of a blown motor at RPMs.
  4. whtpny

    THE RICED OUT MUSTANG!!

    At least it could be turned around before it is too late by the looks of it.
  5. whtpny

    Convertibles

    I did know the reason they fit just meant that some styling things don't mix well sometimes but they go great on the seats.
  6. whtpny

    Dashboard Pad - Still searching for one.Picture attached

    Look up MPS auto salvage. They specialize in Mustangs and may have what you need. http://www.mpsautosalvage.com/
  7. whtpny

    new 5.0

    Do a few searches on here about combos. HCI setups and search on the truck block. I know there is a recent post about compatibilty. I myself am not sure if the truck block was a roller setup or not.
  8. whtpny

    Pully Problem

    There should be 4 bolts that held on the old clutch fan to the water pump with the pulley between them. Find the 4 bolts line up the holes and bolt it in.
  9. whtpny

    Convertibles

    I do like the new edge seats in the fox. They seem too fit right in.
  10. whtpny

    Sunday's photo shoot **pics**

    It is tough to get a good background for a black car. Nice shots.
  11. whtpny

    Pully Problem

    Just put some washers on the old fan bolts or go get some shorter ones and bolt it back on.
  12. whtpny

    Need help truobleshooting!!

    See if there is spark at #8 and pull the plug to see if there is fuel on it.
  13. whtpny

    Convertibles

    Hopefully not too big.
  14. whtpny

    Torque Converters

    Go to www.clickclickracing.com they have good stuff on there
  15. whtpny

    Trick Flow Heads

    Get the heads first. Then save up for the rest of the HCI and do it all at once. I know it will be tough to see the heads sitting there ready to go but way more worth it to do it all.
  16. whtpny

    quick ? bout exhaust setups

    Just resaerch before you commit. Also as far as the money goes. It is worth saving the coin for what you want since the cheaper stuff will need replacing sooner than a better quality stainless setup. I have had a x and an h on a 4.6 with the flowpaths and I liked the x better. But the 4.6 sounds...
  17. whtpny

    I THINK I FRIED MY ELECTRICAL SYSTEM

    I would check all the fuses under the dash as well as under the hood. Something is not getting juice. So no pump when you go straight from the battery then?
  18. whtpny

    convertible frame connectors

    I have a vert and just bought regular subframe connecters. You just have to drill out the rivets on the supports at the rear of the subframe to make them sit flush. Some people even put the plates back on after they modify them for more support.
  19. whtpny

    Before/After pics of springs

    I can do springs on the front at about 35 to 40 minutes per side on the fronts. Just have to learn the tricks man. Looks good!!!
  20. whtpny

    help needed for TCI install

    I am pretty sure you will have to modify the stock crossmember. Look in some back articles of MM&FF and they did the same thing.