Search results

Black 2004 cobras are the best LOL JK

Take care of it. Spark plug wire boot rubber or Coil on plug rubber boots plus oil equals swelled rubber. Eventually you will have a misfire. Just needs the gaskets

Looks like an LFP High flow heat exchanger.

I ran 265/35r18 tires with 9.5 2000 Cobra R wheels and Brembo brake kit with no problems

They come from Ford unpainted. Like a flat black primer color.

I would like to keep cats on the car. my options would be to cut the sections of pipe before the cats and reweld them with a section of the pipe cut out. This way the cats would tuck up better. Option 2 would be buy aftermarket cats that are oval instead of round and would that would give me...

Sold already

I'd like to ask people with the magnaflow catted x pipe if they have any ground clearance issues on a lowered car. I have the eibach sportlines and the SLP pipe I put on hits everything. I'm planning on switching over to the magnaflow pipe. What do you think?

I could pay 70 for the race pipes, but that defeats the purpose in paying the extra money for the cats. I could get oval magnflow cats from Jegs and they would probably work. I put the stock back on for now. I will either cut the front pipes and reweld them shorter so they fit up higher or...

Scraps on my car too. Can't even pull into my garage without taking a chunk out of the concrete. I put the stock pipe back on for now.

I think the sportlines lower the front about 2 inch, not sure though.

Not sure if this is tech or not, but I ordered a catted x pipe from SLP for my eibach sportline lowered 2000 GT. I installed the x pipe and had very little ground clearance because the cats they use are round instead of oval. I would hit bottom going into my garage. I tried adjusting the...

I have the SLP loud mouth, I think it sounds deep and throaty. I actually replaced my rusted out flowmasters with the SLP kit. Sounds much better! It also fit very well. Take it for what it's worth.

The tensioner might be sezied and therefore unable to move. You might need to replace the entire tensioner.

I have the 4 piston brembo front brake kit and was wondering if anyone knows what, if any, 17 inch wheel will work with this kit. I currently have the 2000 cobra R wheels, but would like to know if the older style OEM cobra R wheel would work or the 03 cobra wheel. Thanks

I had the bullitt side scoops on my 2000 GT, but they did not fit very well. I swapped them out for the orginials. They don't clip in very well and you will end up using a lot of double sided tape.