Search results

  1. Z

    NeW CaR pics: plate or no plate??

    I think it goes good with the Hood!
  2. Z

    Tranny problem

    you got a burnt up tranny, You going to need a complete Clutch replacement, AND MAKE SURE THEY DO A DIAGNOSTIC TEST sounds like you got a bad sensor or solenoid, And OD band needs replaced make sure the do a complete Converter flush and make sure its still good. They sould check the mechanicle...
  3. Z

    Installed Balancer with no key

    I wasn't aware of a Key for the balancer, wasn't in the box, The only reason I no about the key is a friend asked if I put it in, What does it do, and where does it go?
  4. Z

    will the 3650 Tranny fit a 97 cobra?

    looking for a tranny my blew today. does it bolt right up do I need anything else like crossmember drive shaft?
  5. Z

    just Blew My 97 Cobra Tranny

    I guess its time for a 6 speed, All i got is 1st gear. does the starter have to come out to remove tranny?
  6. Z

    Anyone know whats needed to put an 03, blower on a 96-98 Cobra

    whats needed to make the 03 blower fit on a 97 cobra? anyone a have Part # list or a go website.
  7. Z

    My suspension squeaks.

    sounds like the rear sway bar, get some anti seize and lube the part were the bar is bolted to the frame.
  8. Z

    anyone ever install a timing chain off a tooth?

    what would happen? or did happen? and did the car sound bad?
  9. Z

    My 97 cobra Temp. gauge stays on the A on NORMAL.

    on the highway it runs between the R and M but on the streets its on the A. only had car for month and it has 48,000 miles.
  10. Z

    OH MY GOD!!! PLEASE HELP!!!

    don't sweat it just use a bolt extracter to get it out or if you don't got room unbolt rad. and slide it out and work on it then, good luck, and you can buy replacement ones,
  11. Z

    My 97 cobra Temp. gauge stays on the A on NORMAL.

    what temp. is that at? thats seems off but my buddys 97 obra has the same problem and so does my buddsy 96 Gt. Should I buy a bigger radiator?
  12. Z

    I set valve train with oil soaked lifters was that wrong?

    i was told to soak lifters before install is this correct? well i torqued my pedastol rockers down to 22Lbs of torque would the lifters filled with oil affect anything?
  13. Z

    Got the motor back in car but somethings not right

    I took my 308 and added some GT-40Y aluminum take off heads and a comp cam specs are: duration-intake-264-Exhaust-276, Gross valve lift .512, its a Nitrous cam loe seperation is 114. and I used stock rockers arms with the heads and stock length hardened push rods, but the shop says something is...
  14. Z

    Best Place to buy a Kenne-Bell Blower

    yea Kenne bell sells them but its alwasys more to buy direct from the manufactor. im hoping for a disturbutor that has good prices
  15. Z

    1.7L KB Results - 398hp / 415ft-lbs torque

    what did yor KB setup Cost?
  16. Z

    Best Place to buy a Kenne-Bell Blower

    I did they won't sell them unless they install it. anywhere else
  17. Z

    Best Place to buy a Kenne-Bell Blower

    I have a 97 Cobra I'm looking for the best price