Search results

Put in a speed-cal today, was working fine, but i had to change the setting and now my speedo isnt working. Checked the ligher fuse, it was blown, so i replaced it. Reset the ecu. Still not working... any ideas?

Medium graphite is gray. That color is brown. I have the same interior. They did not make a tan and gray interior.

brown

1.good used T-45 or 3650 2.flywheel 3.clutch 4.pressure plate 5.throwout bearing 6.pilot bearing 7.clutch fork 8.clutch cable & firewall adjuster 9.clutch cable clip 10.manual wiring harness 11.new yoke or 5spd driveshaft 12.dust shield 13.5spd pedal assembly 14.shifter boot...

SC'd S281s are rated at 365hp at the flywheel. That number seems about right to me.

I have a Bassani catback with the matching catted X pipe. It sounds incredible. I highly recommened this setup.

Nobody knows?

There was no GTS in 96.

Look at your stock pipe, and tell me where you see an X... That's an H pipe.

I'm swapping in a T45, and want to know if i have to get a 5spd bezel with a boot attached to it, or can i use the bezel i already have and just attach a boot to it?

Ok... why not?

Would an 11" clutch from a 2001 cobra work in a 2000 gt? I'll be getting a cobra flywheel as well, since it's an 8 bolt (windsor).

Do aftermarket "high-performance" lifters make noise until the engine is warm on a cold start-up? If so, what does the noise sound like. It's on a 2001 4.6 2V.

.

you do not need them. turn off the sensors with your predator.

whats the difference between your street competition catback and my quiet thunder? btw, ive also got a set i can sell, only 3.5" and one of the hangers is bent.. tried to back up on rhino ramps and got :owned: tips are perfectly fine though.

can you get a pic of how low the lt's hang compared to the rest of the car?

ive got a 1.8" drop and i just drove up a pair yesterday.

no, only the 03 cobra hood since the cobra bumper comes up higher. same reason you dont see 03 cobras with aftermarket hoods, they dont fit.

take out the light and use a blow dryer to dry out the water. then use clear silicone around the lens to make sure its sealed off. had to do this today.